Commercial Metal Roof Repair
Long through-fastened panel runs on ag buildings get end laps, eave closures, fasteners, and gutters repaired from the low end up.
Metal roof repair for Solomon ag buildingsSolomon, AZ
Solomon Commercial Roof Repair
Solomon commercial roof repair for metal ag buildings and shops east of Safford. We repair the end laps, eaves, and gutters that take the runoff from long panel runs.
Runoff At The Bottom Of A Long Panel Run
On a long metal roof, every drop that lands upslope passes over the last few feet before the eave.
Solomon's metal ag buildings often have panel runs that stretch the full depth of the building. In a monsoon downpour all that water reaches the low end at once, and the end laps, eave trim, and gutters there carry the load.
That is why rust and leaks gather along the low eave first. Repairs start there: resealed end laps, new eave closures, and gutters with enough outlets for the flow.
- End laps resealed at the low end of each run
- Eave closures replaced where water backs up
- Gutter seams, straps, and outlets repaired
- Rust treated before it spreads up the panel
Solomon Commercial Roof Repair Signs
On ag buildings, roof problems show up on equipment, stored crops, and walls before anyone climbs up.
In The Building
Rust Along The Low Wall
Orange streaks and flaking paint run down the inside of the low wall, under the eave.
On The Roof
End laps and eave closures at the bottom of the run have failed. We reseal the laps, replace the closures, and treat the rust on the last panel courses.
In The Building
Water Pouring Over The Gutter
During storms a sheet of water falls past the gutter instead of into it, soaking the ground along the wall.
On The Roof
The gutter is clogged, too small for the run, or sagging off its straps. We clean it, reset the straps and pitch, and repair split seams and outlets.
In The Building
Drips Under Skylight Panels
Water drips onto equipment or stored crops directly below a skylight panel.
On The Roof
The skylight's laps or fasteners have loosened, or the plastic has turned brittle. We reseal the laps or replace the panel with a matching profile.
In The Building
Lifted Trim After A Storm
Pieces of trim land on the ground, or a flapping sound starts in the wind after a monsoon storm.
On The Roof
Rake trim and ridge caps have pulled loose. We refasten them with new fasteners and replace bent pieces before the next gust peels more.
Benefits Of Repairing Your Solomon Roof
On a long metal roof, the damage gathers at the low end. Repairing that end saves the rest of the steel.
| Low-End Repair | New Panels Full Length | |
|---|---|---|
| Work area | The last courses, the eave, and the gutter | Every panel from ridge to eave |
| Stored crops and equipment | Stay in place under the existing roof | Often moved or covered during the swap |
| Rust | Treated where it starts | Removed with the old steel |
| Gutters | Repaired and given enough outlets | Replaced with the new edge |
| Best when | The upper panels are solid | Rust has spread up the whole run |
Repairs We Make In Solomon
Two services fit most Solomon buildings: metal roofs and the ag or processing work under them.
Industrial Roof Repair
Gins and processing buildings add dust collectors, fans, and seasonal runs, so repairs are timed around the work inside.
Industrial roof repair for SolomonGutters Overflowing In Every Storm?
Call and tell us how long the building is and where water spills. We look at the low end of the roof first.
How A Solomon Repair Runs
Work starts at the bottom of the roof, where long runs drop their water.
Inspect Your Roof
We walk the full length of the panels, then spend most of the time at the low end: end laps, eave closures, gutters, and outlets.
Measure The Runoff Path
Gutter size, outlet count, and downspout routes are checked against the length of roof feeding them.
Seal The Low End
End laps are opened, cleaned, and resealed, and eave closures are replaced so wind-driven water stops backing up under the panels.
Repair The Gutters
Straps get reset, seams resealed, and outlets cleared or added so a downpour leaves the roof instead of spilling over.
Treat Rust And Report
Rust on the last panel courses is primed and sealed, and you get photos of each repaired lap and gutter section.
Nearby Towns We Serve
Solomon is the easternmost town we cover, on US 70 past Safford.
- Safford
Just west on US 70, where storefront roofs sit behind parapets with dusty scuppers.
- Thatcher
Beyond Safford to the west, where repairs on older buildings match their existing look.
- Pima
Farthest west on US 70, where metal shops are joined to flat additions.
- Swift Trail Junction
South of Safford on US 191, where shop roofs are reached by ladder or lift.
Solomon Roof Repair Questions
Long metal roofs, gutters, skylights, and county permits.
Asked Most
Can Skylight Panels On A Metal Building Be Repaired?
Usually, if the plastic is still whole. On ag buildings, the water tends to get in where the fiberglass or polycarbonate panel laps onto the steel, so we reseal those laps and refasten them like any panel joint.
Yellowed, cracked, or brittle panels get swapped for new ones in the same profile, because a patch will not hold on sun-damaged plastic. Every skylight near the work is screened first, since they are a fall hazard.
Who Issues Permits In Solomon?
Solomon is unincorporated, so roof work there goes through Graham County. Check with the county before work that changes decking, framing, or rooftop equipment curbs.
How Much Rain Falls Here In Summer?
Safford normals for 1991 to 2020 from the Arizona State Climate Office show 1.35 inches in July and 1.84 inches in August, out of 8.78 inches for the year. Those two months bring over a third of the total, and long panel runs feel it at the eave.
Why Do Long Metal Roofs Rust At The Bottom First?
Water, dust, and debris all collect at the low end. End laps there stay wet longest after a storm, and dust packed into a lap holds moisture against the steel.
Do You Repair Gutters On Ag Buildings?
Yes. Gutters on long metal roofs carry heavy flows, so we reset sagging straps, reseal seams, clear outlets, and add outlets where one end of the gutter overflows first.
Can Stored Crops Stay Inside During The Repair?
Usually, yes. Low-end repairs happen from the roof and the eave, so stored crops and equipment can stay put. Skylight swaps over stored material get covered from below first.
Can You Repair Roofs On Older Steel Buildings?
Yes. Older steel buildings get the same lap, fastener, and gutter repairs. If the purlins or framing show heavy rust, we photograph it and tell you before any repair goes on.
Start At The Low End
Request a free estimate for your Solomon building. We repair the eave, laps, and gutters that take the runoff.